Sculpfun s9 laser - Troubleshooting - V1 Engineering Forum

Hi there I’m haveing a problem with my laser machine which is sculpfun s9 The problem is that the machine doesn’t complete any work at all and it stop working in the middle It starts like for less than minute then stop in some point and don’t complete until I reset it then get back to the same problem but it doesn’t stop all time in same place I am using lightburn software and i used lasergrbl and both has the same issue It stop as in this photo and the laser still burning

Wire broke off on sculpfun s9 laser module circuit board - Community Laser Talk - LightBurn Software Forum

Review of the Sculpfun S9 5.5W Diode Laser, with tips and tricks!

Sculpfun s9 negative workspace - LightBurn Hardware Compatibility - LightBurn Software Forum

Sculpfun S9 Laser Modifications

Setting Up Your SCULPFUN Laser With LightBurn & First Project

Rambo 1.4a + Laser - Hardware Development - V1 Engineering Forum

Module laser Neje A40640 40w good or not good - Advice - V1 Engineering Forum

Wire broke off on sculpfun s9 laser module circuit board - Community Laser Talk - LightBurn Software Forum

Sculpfun S9 Upgrade Kit 33 Watt Review - John's Tech Blog

Connect new 15w chinese laser head to sculpfun s9 - Community Laser Talk - LightBurn Software Forum