220V safety control using relay module - General Electronics - Arduino Forum

Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void

Noise from 5v relay - General Electronics - Arduino Forum

I have a relay board but I dont know if it has optocoupler built in? - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino Controlled Auxiliary Relays Wiring Help - General Electronics - Arduino Forum

Buy Relay module 4 channels - 10A/250VAC contacts Botland - Robotic Shop

Controlling AC Devices with Arduino - SAFELY

Relay Controller 4-Channel General Purpose SPDT + 8 Channel ADC ProXR Lite - NCD Store

220v light switch to send HIGH to digital pin - General Electronics - Arduino Forum

Buy Relay 2 channel module with optoisolation - Botland - Robotic Shop

Relay control of 220v 150w fan - General Electronics - Arduino Forum